‘Blemishes’ Spread in Traffic Areas of This Solid Oak Floor

Craig DeWitt Headshot
Problem areas generally occurred along a crack or check in the wood.
Problem areas generally occurred along a crack or check in the wood.

Problem areas generally occurred along a crack or check in the wood.Problem areas generally occurred along a crack or check in the wood.

The Problem

I received a call from a homeowner regarding blemishes in her new floors.

What Happened

Factory-finished solid oak was installed on both levels of a new home in early 2019. Shortly after the home's completion, the homeowner began noticing floor "blemishes," and more occurred over time.

The Inspection

I noticed a textured surface to the flooring, similar to a hand-scraped floor. Multiple locations on both levels of the home had the blemishes, which were primarily in the field rather than along the board edges. Upon closer examination, I saw the blemishes consisted of missing and/or chipped finish, and generally occurred along a crack or check in the wood. Filler was observed at most blemishes but was chipped and missing from the blemishes in some areas. In some blemishes, islands of filler with sanding marks protruded above surrounding filler that did not contain sanding marks. Within most blemishes, the wood protruded above the surrounding area, and the protruding wood appeared to follow a crack or check in the wood. In some areas, the protruding wood formed a ridge in the unbroken finish.

The blemishes were consistent with improper surface preparation during the manufacturing process. The filler did not bond properly with the substrate, which can happen when the surface is contaminated with dust or other material. Improper filler bonding can also occur if it has cured too much before use. Other manufacturing issues did not adequately address the checks and splits in the wood, resulting in raised ridges and unstable edges of the cracks. Subsequent use of the floor resulted in movement along the cracks and separation of the filler and finish from the boards.

How to Fix the Floor

Normally, blemishes can often be individually addressed with spot-applied filler, stain and finish, but since this is a factory-finished textured floor with numerous unblemished ridges along checks and splits as well as unstable wood at existing blemishes, repairing the individual blemishes is not a workable solution. New blemishes will develop with time at the ridges, and wood at the cracks will continue to flex. The floors should be replaced.

In the Future

The manufacturer should make adjustments to address the underlying causes of the filler failure and unsound wood. The installer would not have been able to identify boards with these latent manufacturing issues during the installation.

RELATED: Recoating Prefinished Wood Floors Doesn't Have to Be a Gamble

Page 1 of 11
Next Page
Resource Book
Looking for a specific product or a company? Wood Floor Business has the only comprehensive database of the industry.
Learn More
Resource Book
All Things Wood Floor, created by Wood Floor Business magazine, talks to interesting wood flooring pros to share knowledge, stories and tips on everything to do with wood flooring, from installation, sanding and finishing to business management.
Learn More